| Baltic 147' "VISIONE" |
 |
|
| Design |
Judel/Vrolijk
and R&J Design |
| Yacht description |
Baltic
45 Meter super high-tech sailing yacht that completed construction
in 2002 at Baltic Yachts,
Finland.
The development of this project started one and a half year prior to
production start with a preliminary base hull design followed by a
number of preliminary layout proposals, specifications and detailed
weight calculations
all in close cooperation with the owner. Extensive VPP studies were
carried out on variations from the base design, lighter, heavier, wider,
narrower,
higher and lower prismatic etc. In addition VPP studies were run on
Sloop versus Ketch rigs, water ballast version, canting/lifting keel
versus
deep lifting keel etc. Based on the outcome of the research the decision
was taken to go ahead with the project.
| L.O.A. |
44.85 m |
147.15 ft |
| D.W.L. |
37.66 m |
123.56 ft |
| BEAM |
8.28 m |
27.17 ft |
| B.W.L. |
7.11 m |
23.33 ft |
| DRAFT |
6.80 / 4.10 m |
22.315 / 13.45 ft |
| DISPLACEMENT (SAILING) |
113,650 kg |
250,555 lb |
| BALLAST |
53,470 kg |
109,680 lb |
| IM |
49.750 m |
163.22 ft |
| J |
16.500 m |
53.94 ft |
| P |
47.000 m |
154.20 ft |
| E |
16.200 m |
53.15 ft |
| FUEL |
6,000 l |
1,585 US gal |
| WATER |
2,500 l |
660 US gal |
| MAIN ENGINE |
CAT 3406E 700 hp (522 kW) at 2200 rpm. |
| |
|
|
| Construction |
|
Hull |
Built using intermediate Modulus
prepreg Carbon fibers. Aramide fibers in the outside skin below water
line for added impact resistance. Nomex honeycomb and Core cell core.
Cured under vacuum and high temperature, 85°C (185°F) for 24
hours. |
| Keel |
Keel
fin made from casted Stainless Steel.
Lead bulb |
| Deck |
Built using intermediate modulus
prepreg Carbon fibers. Nomex honeycomb and Core cell core. Cured under
vacuum and high temperature, 85 °C (185 °F) for 24 hours. |
| Deck fittings |
Pulpit, pushpit and lifeline
stanchions made of Titanium tubes. Cleats and fairleads in Titanium.
Large spray hood/cabriolet over forward cockpit.. |
| Interior |
Structural bulkheads in prepreg
Carbon fiber laminates. Laminates made in special laminating press. Visible
surfaces are teak faced. |
|
